Toshiba e-studio281c - Page 214

e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
DRIVE SYSTEM
9 - 20
[H] Main motor (M6)
(12) Remove 1 screw and take off the bracket.
Fig. 9-40
(13) Remove 1 E-ring, 1 bearing, 1 clip and 1
bushing. Remove 5 screws and take off the
gear cover.
Fig. 9-41
(1) Take off the rear cover-2 ( P.2-32 "[S] Rear
cover-2").
(2) Take off the LGC board case
( P.2-38 "[F] LGC board case").
(3) Take off the SYS board case
( P.2-35 "[D] SYS board case").
(4) Disconnect 1 connector, remove 4 screws
and take off the main motor.
Fig. 9-42
Bracket
Gear cover
Clip
Bushing
E-ring
Bearing
Connector
Main motor