11
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
DRUM RELATED SECTION
11 - 11
(4) Remove 1 screw and lay down the interlock
switch bracket completely toward you.
Note:
If the interlock switch bracket does not lie
down completely, pull the harness a little and
then try to lay it down.
Fig. 11-9
(5) Disconnect 3 connectors and remove 2
screws.
Fig. 11-10
(6) Loosen 2 screws and take off the process
unit by pulling it toward you.
Fig. 11-11
Switch bracketHarness
Connector
Connector
Screw
Process unit
06/07
To Next Page
Loading...
