e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
DRUM RELATED SECTION
11 - 12
Note:
At the installation of the process unit, if it cannot be fully inserted, the couplings which transmit
driving force to the transfer belt may be interfering with the unit. Perform the following check, and
then install the process unit again.
Note:
Hold A, B, C and D as shown in the right-
hand figure when handling the process unit.
Fig. 11-12
1. Rotate the transfer belt drive couplings
on the rear frame of the equipment
counterclockwise by 180 degrees.
Fig. 11-13
2. Push all of the 3 transfer belt drive cou-
plings on the rear frame to the inside,
and check if they have slid back to their
original position.
Fig. 11-14
D
C
B
A
06/07
To Next Page
Loading...
