e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
DRUM RELATED SECTION
11 - 22
[O] Toner bag full detection sensor (S20)
(3) Release 2 latches and take off the front posi-
tion switch arm.
(4) Remove 1 screw and take off the rear posi-
tion switch arm.
Fig. 11-42
(5) Disconnect 2 connectors and take off the
front position detection switch and the rear
position detection switch.
Fig. 11-43
(1) Take off the process unit
( P.11-10 "[B] Process unit").
(2) Disconnect 1 connector and remove 1 screw.
Then take off the toner bag full detection
sensor with its bracket.
Fig. 11-44
Front position
switch arm
Rear position
switch arm
Toner bag full detection sensor
To Next Page
Loading...
