Toshiba e-studio281c - Page 269

11
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
DRUM RELATED SECTION
11 - 23
[P] Temperature/humidity sensor (S19)
[Q] Ozone filter
(1) Take off the front cover
( P.2-25 "[A] Front cover").
(2) Take off the front lower cover
( P.2-26 "[E] Front lower cover")
(3) Take off the inner tray ( P.2-26 "[C] Inner
tray").
(4) Take off the left cover
( P.2-29 "[K] Left cover").
(5) Remove 2 screws and take off the left inner
cover.
Fig. 11-45
(6) Disconnect 1 connector and release 2
latches. Then take off the temperature/
humidity sensor.
Fig. 11-46
(1) Remove 1 screw and take off the cover.
(2) Take off the ozone filter.
Fig. 11-47
Screw
Left inner cover
Temperature/Humidity sensor
Latch
Screw
Cover
Ozone filter