Toshiba e-studio281c - Page 270

e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
DRUM RELATED SECTION
11 - 24
[R] Ozone exhaust fan (M18)
(1) Take off the ozone filter
( P.11-23 "[Q] Ozone filter").
(2) Take off the right upper cover
( P.2-28 "[H] Right upper cover").
(3) Take off the right rear hinge cover
( P.2-31 "[P] Right rear hinge cover").
(4) Take off the IH terminal cover
( P.2-30 "[N] IH terminal cover").
(5) Take off the right rear cover
( P.2-30 "[O] Right rear cover").
(6) Take off the rear cove-2
( P.2-32 "[S] Rear cover-2").
(7) Take off the SYS board case.
( P.2-35 "[D] SYS board case")
(8) Take off the flywheel.
( P.9-9 "[A] Developer motor drive unit")
(9) Disconnect 1 connector and remove 3
screws. Then take off the ozone exhaust fan
with its duct.
Fig. 11-48
(10) Release 6 latches and take off the duct.
Then take out the ozone exhaust fan.
Fig. 11-49
Ozone exhaust fan