12
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
DEVELOPER UNIT
12 - 17
[A-3] Black auto-toner sensor (S13)
[A-4] Doctor blade
Note:
When installing the upper cover, make sure
the urethan seal is covered by the upper
cover.
Fig. 12-17
(1) Discharge the developer material
( P.12-16 "[A-2] Developer material").
(2) Disconnect 1 connector, remove 1 screw and
take off the auto-toner sensor.
Fig. 12-18
(1) Discharge the developer material
( P.12-16 "[A-2] Developer material").
(2) Remove 2 screws, release 1 hook and take
off the right cover.
Fig. 12-19
Urethan seal
Screw Black auto toner sensor
Right cover
To Next Page
Loading...
