Toshiba e-studio281c - 3.5.9 Setting range correction; 3.5.10 Setting range correction (Adjustment of background peak); 3.7.7 Setting range correction; 3.7.8 Setting range correction (Adjustment of background peak)

13
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
REVOLVER UNIT
13 - 9
[C] Revolver home position sensor (S8)
[D] Revolver motor (M12)
(3) Disconnect 1 connector and remove 2
screws. Then take off the internal cooling
fan.
Fig. 13-7
(1) Take off the left cover ( P.2-29 "[K] Left
cover").
(2) Disconnect 1 connector and remove 1 screw.
Then take off the revolver home position sen-
sor with the whole bracket.
Fig. 13-8
(1) Take off the LGC board case ( P.2-38 "[F]
LGC board case").
(2) Disconnect 1 connector and remove 2
screws and take off the revolver motor.
Fig. 13-9
Internal cooling fan
Revolver home position sensor
Revolver motor