Toshiba e-studio281c - 3.5.11 Adjustment of smudged;faint text; 3.5.12 Adaptation to highlighter; 3.7.9 Fine adjustment of black density; 3.7.10 RGB conversion method selection

e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
REVOLVER UNIT
13 - 10
[E] Color developer unit drive gear / Color toner supply drive gear
(1) Take off the color developer unit ( P.12-21
"[B] Color developer unit").
(2) Remove 1 screw, release 1 latch and take off
the holder. Then take off the color developer
unit drive gear and color toner supply drive
gear.
Fig. 13-10
Notes:
1. When installing, insert the shaft of the
holder into the revolver unit securely.
2. Apply the grease to the shaft after the
replacement of the gears.
Fig. 13-11
Holder
Grease
Grease
06/07