e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
TRANSFER UNIT
14 - 12
[C] 1st transfer roller
[D] Transfer belt home position sensor-1 (S15)
(1) Take off the transfer belt
( P.14-10 "[B] Transfer belt").
(2) Remove 1 screw.
(3) Take off the holder on the rear side and take
off the 1st transfer roller.
Fig. 14-15
(1) Take off the transfer belt
( P.14-10 "[B] Transfer belt").
(2) Remove 1 screw and take off the cover.
Fig. 14-16
(3) Disconnect 1 connector and remove 1 screw.
Then take off the transfer belt home position
sensor-1.
Fig. 14-17
1st transfer roller
Holder
Screw
Cover
Transfer belt
home position sensor-1
To Next Page
Loading...
