Toshiba e-studio281c - 3.12 Adjustment of the RADF (MR-3018); 3.12.1 Adjustment of RADF Position

14
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
TRANSFER UNIT
14 - 13
[E] Transfer belt home position sensor-2 (S16)
[F] Drum stay
(1) Take off the transfer belt
( P.14-10 "[B] Transfer belt").
(2) Remove 1 screw and take off the cover.
Fig. 14-18
(3) Disconnect 1 connector and remove 1 screw.
Then take off the transfer belt home position
sensor-2.
Fig. 14-19
(1) Take off the process unit
( P.11-10 "[B] Process unit").
(2) Loosen 1 screw and take off the drum stay.
Fig. 14-20
Cover
Transfer belt
home position sensor-2
Drum stay