Toshiba e-studio281c - Page 335

14
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
TRANSFER UNIT
14 - 19
[M] 2nd transfer roller contact clutch (CLT15)
[N] Transfer belt cleaner clutch (CLT1)
(1) Open the 2nd transfer unit.
(2) Disconnect 1 connector and release the har-
ness clamp.
(3) Remove 3 screws and take off the 2nd trans-
fer gear unit ( P.14-16 "[J] 2nd transfer
unit").
(4) Disconnect 1 connector. Remove 1 clip and
take off the 2nd transfer roller contact clutch.
Fig. 14-36
(1) Take off the inner tray ( P.2-26 "[C] Inner
tray").
(2) Disconnect the connector. Remove 1 clip
and slide the bushing to the rear side.
Fig. 14-37
(3) Take off the transfer belt cleaner clutch.
Fig. 14-38
2nd transfer roller contact clutch
Clip
Bushing
Transfer belt cleaner clutch