e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
TRANSFER UNIT
14 - 18
[L] 2nd transfer roller position detection sensor (S18)
(4) Remove 1 screw and the pin on the front
side.
(5) Remove 1 screw and the pin on the rear
side.
(6) Take off the case.
Fig. 14-33
(1) Take off the case ( P.14-17 "[K] Case").
(2) Disconnect 1 connector and release 2
latches and take off the 2nd transfer roller
position detection sensor.
Fig. 14-34
Note:
When reassembling the 2nd transfer cam-
shaft unit, make sure to align the phase of
the partial gear and the cam as shown in the
figure. If the partial gear is incorrectly
installed in a 180-degree reversed position,
an operation abnormality (CEC0: 2nd trans-
fer belt position detection abnormality) may
occur.
Fig. 14-35
Pin
Pin
Case
2nd transfer roller
position detection sensor
Cam
Partial gear
To Next Page
Loading...
