Toshiba e-studio281c - Page 373

16
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
FUSER UNIT / PAPER EXIT SECTION
16 - 31
[K] Exit sensor (S40) / Exit finger / Transport guide
(3) Remove 1 screw of each thermistor and take
off total 3 thermistors.
Note:
When installing, be careful not to deform the
thermistor. Also, make sure that the ther-
mistor is in touch with the fuser belt.
Fig. 16-46
(1) Take off the fuser unit
( P.16-19 "[A] Fuser unit").
(2) Open the jam access cover and transport
guide.
(3) Remove 3 screws and take off the cover (A).
Fig. 16-47
(4) Remove 1 screw and bracket.
(5) Disconnect 1 connector and take off the exit
sensor.
(6) Remove 1 spring.
Fig. 16-48
Thermistor
Cover
(
A
)
Screw
Connector
Bracket
Spring
Exit sensor
Screw