Toshiba e-studio281c - Page 374

e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
FUSER UNIT / PAPER EXIT SECTION
16 - 32
[L] Exit roller
(7) Remove 1 E-ring and pull out the shaft. Then
remove 8 exit fingers and 1 actuator.
Fig. 16-49
(8) Remove 1 screw.
(9) Enlarge the frame and take off the transport
guide.
Fig. 16-50
(1) Take off the fuser unit
( P.16-19 "[A] Fuser unit").
(2) Open the jam access cover of the fuser unit.
(3) Remove 2 screws (one of the front side is a
shoulder screw) and take off the exit roller
cover.
Fig. 16-51
E-ring
3
2
1
Transport guide
Exit roller cover
Shoulder screw