17
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
AUTOMATIC DUPLEXING UNIT (ADU)
17 - 15
[H] ADU motor (M5) / ADU drive unit
(1) Take off the ADU clutch.
( P.17-14 "[G] ADU clutch (CLT7)")
(2) Remove the spring.
Fig. 17-17
(3) Remove 1 screw and take off the ADU rear
latch.
Fig. 17-18
(4) Disconnect 1 connector. Release the har-
ness from 2 harness clamps. Remove 2
screws and take off the ADU drive unit.
Fig. 17-19
Spring
ADU rear latch
ADU drive unit
To Next Page
Loading...
