e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
AUTOMATIC DUPLEXING UNIT (ADU)
17 - 16
[I] Upper transport roller
(5) Remove 2 screws and take off the ADU
motor.
Fig. 17-20
(6) Take off the timing belt and 1 E-ring. Then
take off the gears from the ADU drive unit.
Fig. 17-21
(1) Take off the ADU drive unit.
( P.17-15 "[H] ADU motor (M5) / ADU drive
unit")
(2) Remove 1 E-ring on the rear side. Then take
off 1 pulley.
Fig. 17-22
ADU motor
Gear
Gear
Gear
Timing belt
E-ring
E-ring
Pulley
To Next Page
Loading...
