e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
OUTLINE OF THE MACHINE
2 - 46
(8) Slide the RADF backward and take off by lift-
ing it up.
Fig. 2-80
Note:
When disinstalling the RADF and installing
the platen cover, or disinstalling the platen
cover and installing the RADF, tighten the
screw for installing the damper holding
bracket of the scanner in the following proce-
dure.
• Remove 1 screw and take off the gel
cover.
Fig. 2-81
• Change the position of the screw for
installing the damper holding bracket.
Installing the RADF: A
Installing the platen cover: B
Fig. 2-82
Gel cover
A
B
To Next Page
Loading...
