e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
OUTLINE OF THE MACHINE
2 - 50
(3) Remove 2 screws and take off the rear
cover-1.
Fig. 2-92
(4) Remove 3 screws and take off the rear
cover-2.
Note:
Disconnect the connectors of the RADF first
when the RADF is installed.
Fig. 2-93
(5) Remove 1 screw and the ground wire, and
then disconnect 2 connectors (3 if the
optional damp heater is installed).
Fig. 2-94
Rear cover-1
Rear cover-2
To Next Page
Loading...
