e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 22
(3) Detach the tension springs of the front and
rear sides.
(4) Remove the carriage wires.
Fig. 4-61
(5) Rotate the carriage-2 in the direction where
the inside of the frame is dented shown in
the figure at right, not to touch the mirrors.
Then take off the carriage-2.
• When replacing the mirrors-2 and -3,
replace the carriage-2 together with
mirrors-2 and -3. Mirrors-2 and -3 should
not be removed.
• When installing carriage-2, fix the front
bracket temporarily and move it in the
direction of (B) after the wires are
installed. Then push it to the end and fix it
securely.
Fig. 4-62
Tension spring
Tension spring
(
B
)
To Next Page
Loading...
