4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 23
[B] Installing carriage wires
(1) When replacing the carriage wires, refer
illustrations below:
Adjustment of the carriage wire tension is not
necessary since a certain tension is applied
to the carriage wires by the tension
springs.Make sure the tension applied to the
wire is normal.
Fig. 4-63
Fig. 4-64
[Front]
Wire pulley
Bracket for carriage-1
Carriage wire
Carriage-2
Idler pulley
Hook
Tension spring
[Rear]
Carriage-2
Carriage wire
Bracket for carriage-1
Hook
Wire pulley
Tension spring
Idler pulley
To Next Page
Loading...
