Toshiba e-STUDIO656 - Page 170

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 24
[C] Winding the wires around the wire pulley
(1) Pull the O3 ball terminal located at the center
of the wire into a hole on the wire pulley. One
end of the wire with a hook attached comes
to the outside.
(2) Wind the wires around the wire pulleys of the
front and rear sides. The number of turns to
be wound are as follows:
2 turns toward the opposite side of the boss
4 turns toward the boss side
Notes:
Pay attention to the followings when the
wires are wound around the pulleys:
• Do not twist the wire.
• Wind the wires tightly so that they are in
complete contact with the surface of the
pulleys.
• Each turn should be pushed against the
previously wound turn so that there is no
space between them.
Fig. 4-65
Fig. 4-66
(3) After winding the wires around the pulleys,
attach the wire holder jigs not to loosen the
wires.
Notes:
• When the wire holder jig is attached,
make sure that the wire is not shifted or
loosened.
• The wire should come out of the slot of
the wire holder jig and be passed under
the arm of it.
Fig. 4-67
[
Rear
]
2 turns 4 turns
Ball terminal
Hook
Color: Silver
No space between turns
4 turns 2 turns
[
Front
]
No space between turns
Color: Black
Hook
Ball terminal
Arm
Wire holder jig
Wire holder jig