e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 110
[CC00] Sensor connector connection error abnormality
[Procedure 1]
Is the guide home position sensor (PI13S) connected to the saddle stitcher controller PC
board?
NO Connect it to the board.
YES
Is the wiring between the sensor and the saddle stitcher correct?
YES Correct the wiring.
NO
Is 5V DC being supplied from J9-7 on the saddle stitcher controller PC board?
NO Replace the saddle stitcher controller PC board.
YES
Is J9-8 on the saddle stitcher controller PC board correctly connected to the ground?
NO Replace the saddle stitcher controller PC board.
YES
END
[Procedure 2]
Is the paper pushing plate home position sensor (PI14S) connected to the saddle stitcher
controller PC board?
NO Connect it to the board.
YES
Is the wiring between the sensor and the saddle stitcher correct?
YES Correct the wiring.
NO
Is 5V DC being supplied from J9-10 on the saddle stitcher controller PC board?
NO Replace the saddle stitcher controller PC board.
YES
Is J9-11 on the saddle stitcher controller PC board properly connected to the ground?
NO Replace the saddle stitcher controller PC board.
YES
END
To Next Page
Loading...
