12
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
BACKUP FUNCTION
12 - 3
[B] Restoring procedure
(1) Shut down the equipment.
(2) Connect the USB media to the USB port on the right upper cover.
Fig. 12-2
Restoring cannot be performed with multiple USB media connected at the same time.
(3) Turn the power ON while pressing the [5] and [9] buttons simultaneously.
(4) Enter the password, and then press the [OK].
(If the password is not set for Service, press the [OK] without entering anything.)
(5) Select "2. Restore SRAM Data from USB", and then press the [START] button.
(6) Enter a password (max. 15 characters) set for the backup data.
(7) Enter the serial number of the backup file.
(8) "Restore successfully done" is displayed on the LCD screen when the restoring has been
properly completed.
(9) Turn the power OFF after the restoring is completed.
USB media
USB port
To Next Page
Loading...
