e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
BACKUP FUNCTION
12 - 4
[C] Confirmation of the error
“Backup Failed” is displayed on the lower left part of the LCD screen when the data have not been
properly backed up or restored.
Moreover, details of an error are displayed under the above message.
(The following is an example screen when “USB device not detected” is displayed.)
Fig. 12-3
In this case, turn the power OFF and then check the following items. After confirming and solving the
problem, back up / restore the data again from the beginning.
• Does the USB media meet the conditions being used for this cloning?
• Is the updated program file written on the USB media properly?
• Is the USB media installed properly?
• Is the USB media or the equipment damaged?
Backup
Display content Error content
USB device not detected
The USB media has not been installed.
SRAM Device Not Connected The SRAM board has not been installed.
Backup not created Creation of the Backup file of data of the SRAM board has been failed.
Encryption Failed An encryption of the backup file has been failed.
password Not Appended to Backup Addition of the encryption password has been failed.
MFP Serial Number Not Set Acquisition of the MFP Serial No. has been failed.
Restore
Display content Error content
USB device not
detected
The USB media has not been installed.
SRAM Device Not Connected The SRAM board has not been installed.
Invalid Backup File The SYS board has not been recognized.
No Backup File Exists Backup file has not existed in the USB media.
Invalid password An incorrect password has been entered.
Decryption Failed Decoding of the backup file has been failed.
Invalid MFP Serial Number:
xxxxxxxxx
An incorrect MFP Serial No. has been entered.
MFP Serial Number Not Set Acquisition of the MFP Serial No. has been failed.
Backup File Corrupted A backup file has been damaged.
Download Storage Firmware Update Mode Firmware Version : x. x. x. x
Select number (1-2) and press START key
Backup Failed
USB device not detected
Update Mode : 59 Mode
To Next Page
Loading...
