GX9 ASD Installation and Operation Manual 249
Frequency Control, 56
Frequency Control Selections, 69
Frequency for Automatic High-Speed Operation at
Light-Load, 140
Frequency Limit at Position, 145
Frequency Mode 1, 76
Frequency Mode 2, 45, 109
Frequency Mode Priority Switching Frequency, 109
Frequency Point Selection, 202
Frequency Priority Selection, 105
Frequency Reference, 41
Frequency Set Mode, 39
Frequency Setting, 45
Fundamental, 45
Fwd/Rev Disable, 50
G
Gate Array Fault, 229
General Safety Information, 1
H
Handling and Storage, 3
Heavy-Load Torque During Acceleration in the Forward
Direction, 139
Heavy-Load Torque During Deceleration in the Forward
Direction, 139
Heavy-Load Torque During Deceleration in the Reverse
Direction, 140
Heavy-Load Torque During Reverse Acceleration, 140
High-Speed Operation at Light Load, 138
I
I/O and Control, 20
ICCDESIGNS, 25
II, 20
II terminal, 22
IICC, 106, 108
Important Notice, 4
Input Phase Failure, 229
Input Power, 42
Input Special Functions, 48
Input Terminal 1 (F) Function, 89
Input Terminal 1 (F) Response Time, 95
Input Terminal 10 (LI2) Function, 91
Input Terminal 11 (LI3) Function, 91
Input Terminal 12 (LI4) Function, 91
Input Terminal 13 (LI5) Function, 92
Input Terminal 14 (LI6) Function, 92
Input Terminal 15 (LI7) Function, 92
Input Terminal 16 (LI8) Function, 93
Input Terminal 2 (R) Function, 89
Input Terminal 2 (R) Response Time, 95
Input Terminal 3 (ST) Function, 89
Input Terminal 3 (ST) Response Time, 95
Input Terminal 4 (RES) Function, 89
Input Terminal 4 (RES) Response Time, 96
Input Terminal 5 – 8 (S1 – S4) Response Time, 96
Input Terminal 5 (S1) Function, 90
Input Terminal 6 (S2) Function, 90
Input Terminal 7 (S3) Function, 90
Input Terminal 8 (S4) Function, 90
Input Terminal 9 – 16 (S5 – S12) Response Time, 96
Input Terminal 9 (LI1) Function, 90
Input Terminal Delays, 48
Input Terminal Priority Selection, 86
Input Terminals, 47
Inrush Current Suppression, 186
Installation and Connections, 15
Installation Notes, 15
Installation Precautions, 4
isolated V/I input, 106
J
Jog Run Frequency, 126
Jog Settings, 49
Jog Setup Using the EOI, 126
Jog Stop Pattern, 126
Jump Frequencies, 56
Jump Frequency 1, 127
Jump Frequency 1 Bandwidth, 127
Jump Frequency 2, 127
Jump Frequency 2 Bandwidth, 127
Jump Frequency 3, 128
Jump Frequency 3 Bandwidth, 128
Jump Frequency Processing Selection, 128
Jumper PCB (P/N 55365) is required at the J4, 25
L
LCD Character/Font Information, 34
LCD Screen, 33
LCD Screen Display, 34
Lead Length Specifications, 19
LED Character/Font Information, 34
LED Option Override Multiplication Gain, 197
LED Screen, 33
LED Screen Display, 34
LED/LCD Screen Information, 34
Light Load Conditions, 12
Light-Load High-Speed Operation Heavy-Load Detec-
To Next Page
Loading...
