Toshiba HX7+ ASD - Page 253

244 HX7+ ASD Installation and Operation Manual
OUT2 Output Terminal Assignment, 88
OUT2 terminal, 30
OUT4 Off Delay, 93
OUT4 On Delay, 92
OUT5 Off Delay, 93
OUT5 On Delay, 92
OUT6 Off Delay, 94
OUT6 On Delay, 92
OUT7 Off Delay, 94
OUT7 On Delay, 92
Outdoor systems, 205
Output #4 Terminal Assignment, 89
Output #5 Terminal Assignment, 89
Output #6 Terminal Assignment, 89
Output #7 Terminal Assignment, 90
Output Current Protection Fault, 200
Output Disconnect, 9
Output Phase Loss, 200
Output Phase Loss Detection, 169
Output Terminal Delays, 62
Output Terminal Functions, 61
Output terminal selections, 193
Over Exciting Cooperation, 151
Over Speed, 201
Overcurrent During Acceleration, 201
Overcurrent During Deceleration, 201
Overcurrent During Run, 201
Over-Current Protection, 20
Overcurrent Stall Level, 168
Overheat, 201
Overload, 64
Overload Protection, 17
Override Control, 66
Override mode, 48
Overspeed Detection Frequency Range, 172
Overtorque, 201
Overtorque Detection Time, 171
Overtorque Settings, 64
Overtorque Trip, 171
Overtorque Trip/Alarm Level (Negative Torque), 171
Overtorque Trip/Alarm Level (Positive Torque), 171
Overvoltage During Acceleration, 201
Overvoltage During Deceleration, 202
Overvoltage During Run, 202
Over-voltage Stall, 127
Overvoltage Stall Level, 173
Overvoltage Stall Level (fast), 172
P
P24, 28
P24 terminal, 30
PA, 126
PA/+, 24
Parameter Changes, 37
Parity, 184
Pattern #1 Characteristics (Pattern Run), 163
Pattern #10 Characteristics (Pattern Run), 164
Pattern #11 Characteristics (Pattern Run), 164
Pattern #12 Characteristics (Pattern Run), 165
Pattern #13 Characteristics (Pattern Run), 165
Pattern #14 Characteristics (Pattern Run), 165
Pattern #15 Characteristics (Pattern Run), 165
Pattern #2 Characteristics (Pattern Run), 164
Pattern #3 Characteristics (Pattern Run), 164
Pattern #4 Characteristics (Pattern Run), 164
Pattern #5 Characteristics (Pattern Run), 164
Pattern #6 Characteristics (Pattern Run), 164
Pattern #7 Characteristics (Pattern Run), 164
Pattern #8 Characteristics (Pattern Run), 164
Pattern #9 Characteristics (Pattern Run), 164
Pattern Run, 66, 159
Pattern Run #1 Run-Time Setting, 165
Pattern Run #10 Run-Time Setting, 167
Pattern Run #11 Run-Time Setting, 167
Pattern Run #12 Run-Time Setting, 167
Pattern Run #13 Run-Time Setting, 167
Pattern Run #14 Run-Time Setting, 167
Pattern Run #15 Run-Time Setting, 167
Pattern Run #2 Continuation Mode Run-Time Setting,
165
Pattern Run #3 Run-Time Setting, 165
Pattern Run #4 Run-Time Setting, 166
Pattern Run #5 Run-Time Setting, 166
Pattern Run #6 Run-Time Setting, 166
Pattern Run #7 Run-Time Setting, 166
Pattern Run #8 Run-Time Setting, 166
Pattern Run #9 Run-Time Setting, 166
Pattern Run Control Parameters, 66
Pattern Run Description, 159
Pattern Run Setup, 159
PB, 126
PC/-, 24
PG Disconnect Detection, 136
PG Input Phases, 136
PG Input Speed Control Setup, 116
PG Settings, 65
PG Speed Frequency #1, 117
PG Speed Frequency #2, 117
PG Speed Reference #1, 116
PG Speed Reference #2, 117
PG Type/Connection Error, 202
Phantom Fault, 202
Phase Loss, 64
PID feedback, 135, 181
PO, 24
POFF, 198