3 Tests and Diagnostics 3.31 SETUP
3-100 [CONFIDENTIAL] QOSMIO F20 Maintenance Manual (960-526)
6. Display
This group of options configures the computer’s display.
(a) Power On Display
This option is used to select the display when booting up.
Auto-Selected Selects an external monitor if one is connected. Otherwise it
selects the internal LCD. (Default)
LCD+AnalogRGB Selects both the internal LCD and the external monitor for
simultaneous display.
NOTE: When starting the computer in Resume mode, the last configuration is enabled.
When data does not appear on the display after starting in Resume mode,
pressing Fn+F5. Pressing Fn+F5 changes the display setting as follows in order:
the internal LCD, the external display, both the internal LCD and the external
display.
You cannot select TV display in HW Setup. To display on a TV screen, use
Fn+F5.
When an external monitor, which does not support SVGA mode is connected and
“LCD+AnalogRGB” is selected, the external display is not displayed.
(b) LCD Display Stretch
When LCD Display Stretch is enabled, it is possible to stretch the picture in small
resolution mode.
Enabled Enables the LCD display stretch feature. (Default)
Disabled Disables the LCD display stretch feature.
(c) TV Type
This option allows you to select the type of TV.
NTSC (Japan) TV in Japanese system
NTSC (US) TV in the U.S. system
PAL TV in Europe and China system
To Next Page
Loading...
Need help?
General