⎯ 52 ⎯
6 F 2 S 0 7 1 5
• Enter “None” not to record events.
• Enter “Operate” to record the event when the status changes to “operate”.
• Enter “Reset” to record the event when the status changes to “reset”.
• Enter “Both” to record the event when the status changes both to “operate” and “reset”.
On the [Disturbance] screen, the recording time, threshold level of starter measuring elements, use
of the trip command as a starter, and the use or non-use switch for each starter measuring element
can be set.
Depending on the relay types, [Fault record], [D.rec/E.rec] and [Counter] are included as follows:
To Next Page
Loading...