3 Tests and Diagnostics 3.30 BIOS SETUP
3-92 [CONFIDENTIAL] TECRA A9(S5/P5/S200) Maintenance Manual (960-633)
Critical Battery Wake-up
Configures what action is taken when the remaining battery power is close to
running out while the system is in Sleep Mode. This setting is only available
when the Critical battery action within Power Options in Windows is set to
Hibernate. (Default)
The operation of this function is dependent upon battery status.
Note: The Critical Battery Wake-up only operates with Windows Vista™.
Enabled When the remaining battery power is about to run out while
the system is in Sleep Mode, the system is automatically
woken up and then switched to Hibernation Mode
(Default).
Disabled No action is taken even if the remaining battery power is
about to run out while the system is in Sleep Mode.
Warning Turning off your computer where electronic devices are
regulated or controlled. When you have to turn off your
computer aboard an aircraft or in places where electronic
devices are regulated or controlled, always shut down the
computer completely or put the computer into Hibernation
Mode instead of allowing it to go into Standby Mode
(Sleep Mode) and turn off any wireless communication
switches or devices. While in Standby Mode (Sleep Mode),
the computer operating system may reactivate itself to run
preprogrammed tasks or to preserve unsaved data, and
might interfere with aviation or other systems, possibly
causing serious injury.
(f) Beep Volume
This option selects the volume of beep (Warning). “OFF”, “Low”, “Medium”
(Default) or “High” can be selected. If a memory module that does not comply
with the standards, the computer beeps at maximum volume.
(f) Diagnostic Mode
This option sets whether the BIOS Setup Diagnostic test is enabled.
Disabled The Diagnostic test is disabled. (Default)
Enabled The Diagnostic test is enabled.
To Next Page
Loading...
Need help?
General
