E6580516
Trip occurrence example
(Overvoltage
trip occurrence during deceleration)
Key operation
Example display
Explanation
[J,02
Standard monitor
mode
(Trip display will blink)
The
motor enters
the
coast-stop state.
8
.
ynn
U•U
Operating frequency at time
of
trip
@]
:,C
,-
-
,c
Run direction
at
time of trip
@]
.
so.o
Operating frequency command value at time
of
trip Note)
@]
.,-
:
30
Load current (%) at time
of
trip
Note)
•I..
@]
:1=12sa
Input voltage (V) at time of trip
Note)
@]
:,O :so
Output voltage (V)
at
time of trip Note)
@]
:R,,,,,,
Input terminal status at time of trip
@]
:f=,1:1111
Input terminal status at time of trip
@]
•r'll"'
Output terminal status at time
of
trip
·Ullllll
If there are past trips, the trip status information for a max. of four trips can be displayed in the same
manner. If I MON I is pressed,
the
initial display will be returned to.
If the
@)
key is held down during the above steps, the display will change to the next item every 0.5 sec.
The trip title display state can
be
changed to if the I MON I key is pressed at any time.
*
The
trip status monitor function will remain active until power is turned
OFF
or the trip is cleared.
Note)
The
display will follow In [1,-, : I to In 0
,-,
'-I I in c
,-
.
LI
c .
Other monitor items can be displayed by changing the settings of
Inc:,-,
: I to
Inc:,-,
'-:I
before
clearing the trip.
The
fault trip hold function will not maintain fault status after
power
is turned off, after a reset, or
if
a
fault occurs during CPU initialization. Instead, the current monitor item will be displayed. I
- 39 -
To Next Page
Loading...
