User Guide 116
Configuring LAG LAG Configuration
Note:
Clearing all member ports will delete the LAG.
â– Configuring LACP
Choose the menu L2 FEATURES > Switching > LAG > LACP to load the following page.
Figure 2-4 LACP Config
Follow these steps to configure LACP:
1) Specify the system priority for the switch and click Apply.
System Priority Specify the system priority for the switch. A smaller value means a higher priority.
To keep active ports consistent at both ends, you can set the system priority
of one device to be higher than that of the other device. The device with higher
priority will determine its active ports, and the other device can select its active
ports according to the selection result of the device with higher priority. If the two
ends have the same system priority value, the device with a smaller MAC address
has the higher priority.
2) Select member ports for the LAG and configure the related parameters. Click Apply.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General