User Guide 178
Configuring Protocol VLAN Protocol VLAN Configuration
The following example shows how to create an IPv6 protocol template:
Switch#configure
Switch(config)#protocol-vlan template name IPv6 frame ether_2 ether-type 86dd
Switch(config)#show protocol-vlan template
Index Protocol Name Protocol Type
------- ----------------- --------------------------------
1 IP EthernetII ether-type 0800
2 ARP EthernetII ether-type 0806
3 RARP EthernetII ether-type 8035
4 IPX SNAP ether-type 8137
5 AT SNAP ether-type 809B
6 IPv6 EthernetII ether-type 86DD
Switch(config)#end
Switch#copy running-config startup-config
2.2.3 Configuring Protocol VLAN
Follow these steps to configure protocol VLAN:
Step 1 configure
Enter global configuration mode.
Step 2 show protocol-vlan template
Check the index of each protocol template.
Step 3 protocol-vlan vlan
vid
priority
priority
template
index
Bind the protocol template to the VLAN.
vid
: Enter the ID number of the 802.1Q VLAN that will be bound to the Protocol VLAN.
priority
: Specify the 802.1p priority for the packets that belong to the protocol VLAN. The
switch will determine the forwarding sequence according this value. The packets with larger
value of 802.1p priority have the higher priority.
index
: Specify the protocol template index.
Step 4 show protocol-vlan vlan
Check the protocol VLAN index (entry-id) of each protocol group.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General