Configuring Access Security Access Security Configurations
User Guide 509
Port Select one or more ports. Only the users who are connected to these ports can
access the switch via the specified interfaces.
3) Click Create. Then you can view the created entries in the table.
2.1.2 Configuring the HTTP Function
Choose the menu SECURITY > Access Security > HTTP Config to load the following page.
Figure 2-5 Configuring the HTTP Function
1) In the Global Control section, enable HTTP function, specify the port using for HTTP,
and click Apply to enable the HTTP function.
HTTP HTTP function is based on the HTTP protocol. It allows users to manage the
switch through a web browser.
Port Specify the port number for HTTP service.
2) In the Session Config section, specify the Session Timeout and click Apply.
Session
Timeout
The system will log out automatically if users do nothing within the Session
Timeout time.
3) In the Number of Access Users section, enable Number Control function, specify the
following parameters and click Apply.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
