User Guide 506
Configuring Access Security Access Security Configurations
2
Access Security Configurations
With access security configurations, you can:
■ Configure the Access Control feature
■ Configure the HTTP feature
■ Configure the HTTPS feature
■ Configure the SSH feature
■ Configure the Telnet function
2.1 Using the GUI
2.1.1 Configuring the Access Control Feature
Choose the menu SECURITY > Access Security > Access Control to load the following
page.
Figure 2-1 Configuring the Access Control
1) In the Global Config section, enable Access Control, select one control mode and click
Apply.
Control Mode Choose how to control the users’ access.
IP-based: Only the users within a certain IP-range can access the switch via the
specified interfaces.
MAC-based: Only the users with a certain MAC address can access the switch via
the specified interfaces.
Port-based: Only the users who are connected to certain ports can access the
switch via the specified interfaces.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
