User Guide 649
Configuring IPv4 IMPB IPv4 Source Guard Configuration
4
IPv4 Source Guard Configuration
To complete IPv4 Source Guard configuration, follow these steps:
1) Add IP-MAC Binding entries.
2) Configure IPv4 Source Guard.
4.1 Using the GUI
4.1.1 Adding IP-MAC Binding Entries
In IPv4 Source Guard, the switch filters the packets that do not match the rules of IPv4-
MAC Binding Table. So before configuring ARP Detection, you need to complete IP-MAC
Binding configuration. For details, refer to IP-MAC Binding Configuration.
4.1.2 Configuring IPv4 Source Guard
Choose the menu SECURITY > IPv4 IMPB > IPv4 Source Guard to load the following page.
Figure 4-1 IPv4 Source Guard Config
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General