User Guide 182
Configuring Protocol VLAN Configuration Example
1) Create VLAN 10 and VLAN 20 and add each port to the corresponding VLAN.
2) Use the IPv4 protocol template provided by the switch, and create the IPv6 protocol
template.
3) Bind the protocol templates to the corresponding VLANs to form protocol groups, and
add port 1/0/1 to the groups.
For Switch 1, configure 802.1Q VLAN according to the network topology.
Demonstrated with T1500-28PCT, this chapter provides configuration procedures in two
ways: using the GUI and using the CLI.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
