User Guide 256
Configuring Layer 2 Multicast Multicast Filtering Configuration
Figure 5-1 Create IPv4 Profile
Follow these steps to create a profile.
1) In the General Config section, specify the Profile ID and Mode.
Profile ID Enter a profile ID between 1 and 999.
Mode Select Permit or Deny as the filtering mode.
Permit: Acts as a whitelist and only allows specific member ports to join specified
multicast groups.
Deny: Acts as a blacklist and prevents specific member ports from joining specific
multicast groups.
2) In the IP-Range section, click
to load the following page. Configure the start IP
address and end IP address of the multicast groups to be filtered, and click Create.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
