Configuring Layer 2 Multicast Multicast Filtering Configuration
User Guide 259
Step 3 Permit
Configure the profile’s filtering mode as permit. Then the profile acts as a whitelist and only
allows specific member ports to join specified multicast groups.
deny
Configure the profile’s filtering mode as deny. Then the profile acts as a blacklist and prevents
specific member ports from joining specific multicast groups.
Step 4 range
start-ip end-ip
Configure the range of multicast IP addresses to be filtered.
start-ip
/
end-ip:
Specify the start IP address and end IP address of the IP range.
Step 5 show ip igmp profile [
id
]
Show the detailed IGMP profile configuration.
Step 6 end
Return to privileged EXEC mode.
Step 7 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to configure Profile 1 so that the switch filters multicast
streams sent to 226.0.0.5-226.0.0.10:
Switch#configure
Switch(config)#ip igmp snooping
Switch(config)#ip igmp profile 1
Switch(config-igmp-profile)#deny
Switch(config-igmp-profile)#range 226.0.0.5 226.0.0.10
Switch(config-igmp-profile)#show ip igmp profile
IGMP Profile 1
deny
range 226.0.0.5 226.0.0.10
Switch(config)#end
Switch#copy running-config startup-config
Creating MLD Profile (Multicast Profile for IPv6)
Step 1 configure
Enter global configuration mode.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General