TP-Link T2500G-10TS - Policy Config; Policy Summary

177
Rule ID:
Enter the rule ID.
Operation:
Select the operation for the switch to process packets which match
the rules.
 Permit: Forward packets.

Deny: Discard Packets.
S-IP:
Enter the source IP address contained in the rule.
D-IP:
Enter the destination IP address contained in the rule.
Mask:
Enter IP address mask. If it is set to 1, it must strictly match the
address.
IP Protocol:
Select IP protocol contained in the rule.
TCP Flag
：
Configure TCP flag when TCP is selected from the pull-
down list of IP
Protocol.
S-Port: Configure TCP/IP source port contained in the rule when TCP/UDP is
selected from the pull-down list of IP Protocol.
D-Port: Configure TCP/IP destination por
t contained in the rule when
TCP/UDP is selected from the pull-down list of IP Protocol.
DSCP:
Enter the DSCP information contained in the rule.
IP ToS:
Enter the IP-ToS contained in the rule.
IP Pre:
Enter the IP Precedence contained in the rule.
Time-Range:
Select the time-range for the rule to take effect.
11.3 Policy Config
A Policy is used to control the data packets those match the corresponding ACL rules by
configuring ACLs and actions together for effect. The operations here include stream mirror,
stream condition, QoS remarking and redirect.
The Policy Config can be implemented on Policy Summary, Police Create and Action Create
pages.
11.3.1 Policy Summary
On this page, you can view the ACL and the corresponding operations in the policy.
Choose the menu ACL→Policy Config→Policy Summary to load the following page.