TP-Link TL-SG3109 - Snmp-Server Trap Authentication

snmp-server trap authentication
The snmp-server trap authentication Global Configuration mode command enables the device to send SNMP
traps when authentication fails. To disable SNMP failed authentication traps, use the no form of this command.
Syntax
snmp-server trap authentication
no snmp-server trap authentication
Default Configuration
SNMP failed authentication traps are enabled.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Examples
The following example enables SNMP failed authentication traps.
Console(config)# snmp-server trap authentication
TL-SG3109/TL-SL3428/TL-SL3452 Gigabit Managed Switch Family CLI Reference Guide
Page 208