TP-Link TL-SG3210 - Lldp Med-Tlv-Select

Status will be changed to Tx&Rx. To disable the LLDP-MED feature for the
corresponding port, please use no lldp med-status command.
Syntax
lldp med-status
no lldp med-status
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable the LLDP-MED feature for port 2:
TL-SG3424P(config)# interface gigabitEthernet 1/0/2
TL-SG3424P(config-if)# lldp med-status
lldp med-tlv-select
Description
The lldp med-tlv-select command is used to configure LLDP-MED TLVs to be
included in outgoing LLDPDU for the corresponding port. To exclude LLDP-MED
TLVs, please use no lldp med-tlv-select command. By default, All TLVs are
included in outgoing LLDPDU.
Syntax
lldp med-tlv-select { [inventory-management] [location] [network-policy]
[power-management] [all] }
no lldp med-tlv-select { [inventory-management] [location] [network-policy]
[power-management] [all] }
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Exclude “network policy” and “inventory” TLVs in LLDPDU outgoing from port 2:
TL-SG3424P(config)# interface gigabitEthernet 1/0/2
TL-SG3424P(config-if)# no lldp med-tlv-select network-policy
inventory-management
261