The following table gives detailed information about the Accessing path, Prompt of each mode and
how to exit the current mode and access the next mode.
Mode Accessing Path Prompt Logout or Access the next mode
Mode
Primary mode once it
is connected with the
switch.
TL-SG3424>
Use the exit command to disconnect the
switch (except that the switch is
connected through the Console port).
Use the enable
Privileged EXEC mode.
Privileged
EXEC Mode
Use the enable
command to enter this
mode from User EXEC
mode.
TL-SG3424#
Enter the disable or the exit command
to return to User EXEC mode.
Enter configure
Global Configuration mode.
Global
Configuration
Mode
Use the configure
command to enter this
mode from Privileged
EXEC mode.
TL-SG3424 (config)#
Use the exit or the end
press Ctrl+Z to return to Privileged
EXEC mode.
Use the interface gigabitEthernet port
or interface
port-list command to access interface
Configuration mode.
Use the vlan vlan-list to access VLAN
Configuration mode.
Interface
Configuration
Mode
Use the interface
gigabitEthernet port
or interface range
gigabitEthernet
port-list command to
enter this mode from
Global Configuration
mode.
TL-SG3424
(config-if)# or
TL-SG3424
(config-if-range)#
Use the end command or press Ctrl+Z
to return to Privileged EXEC mode.
Enter the exit or the #
return to Global Configuration mode.
A port number must be specified in the
interface command.
VLAN
Configuration
Mode
Use the vlan vlan-list
command to enter this
mode from Global
Configuration mode.
TL-SG3424
(config-vlan)#
Use the end command or press Ctrl+Z
to return to Privileged EXEC mode.
Enter the exit or the #
return to Global configuration mode.
Global Configuration
Privileged EXEC
Interface Configuration Mode
Interface gigabitEthernet
Interface link-aggregation
Interface range gigabitEthernet
Interface range link-aggregation
Interface vlan
password
15