TPT Wirebonder www.tpt.de Page 31 of 53 September 2016
29. Option H53 "Pull Tester"
Mechanical pull tester for destructive bond tests
Installation on bond head with easy take on & off
Works on the complete bonder range HB02 - HB16
H51 „Manual-Z“ or H52 „Dynamic Search“ required
Measurement gauges max.15g or 30g
Installation Holder for Pull Tester
Remove screw at glass tube Install holder with long screw
Secure glass tube with M4 nut attach Pulltester arm to holder and tighten M2 screw
Test Position Rest Position
To Next Page
Loading...