7. For increased security, select the Use IEEE 802.1x network access control check box and then
configure additional authentication information.
8. Tap Finish.
Step 2: Connecting to the network or access point
1. Disconnect the USB data cable, as the handheld prioritizes a USB connection over a Wi-Fi
connection.
2. Bring the handheld within range of the network or access point.
When a Wi-Fi connection is detected, the access point icon appears on the title bar.
If the access point icon does not appear, use the Wireless Manager to turn off and then turn back
on the Wi-Fi radio. When the Wi-Fi radio is turned on, any networks or access points within range
are detected and the icon appears.
3. Tap the access point icon on the title bar. A popup message shows the available networks.
4. Select the network you want to connect to and then tap OK.
5. Select The Internet (or work via a VPN) or Work and then tap Connect.
6. If a Network Log On screen appears, enter your user name, password, and domain information and
then tap OK.
7.
When the handheld is connected to the network or access point, the Wi-Fi connected icon
appears in the title bar.
8. Start using the program you want to use, for example Windows Explorer Mobile or Internet
Explorer.
Note – To disconnect from the network or an access point at any time, turn off the handheld’s wireless
radio. To do this, tap title bar, tap the Connectivity icon on the pull-down list, select Wireless Manager
and then tap the Wi-Fi button.
Tip – To delete a Wi-Fi connection, tap and hold the connection in the Wireless tab of the Wi-Fi Settings screen and
then select Remove Settings.
Using the Summit Client Utility to manage Wi-Fi connections
Summit Client Utility (SCU) is a Wi-Fi connection management and monitoring utility which enables you
to view all radio and security settings and status, and to troubleshoot connectivity issues.
The SCU software is useful for establishing network connections that require more complex settings than
the Configure Wireless Network wizard provided in the Windows Embedded Handheld operating system.
1. Make sure that the handheld’s Wi-Fi radio is enabled (see page 43).
2.
Tap / Settings / Connections / . The Summit Client Utility window appears.
The SCUhas five screens:
To Next Page
Loading...
Need help?
General
