Easy-to-use keypad and user-friendly menus to
reduce training time to increase productivity.
A remote keypad, including a START and
ESC key, at the top of its source rod housing.
These keys perform the same function as the
keys on the control panel.
An internally mounted beeper, which emits a
short tone in response to a valid keystroke on
the keypad. The beeper sounds a longer tone if
you press an invalid key, if the gauge displays an
error message, or to signal the conclusion of a
measurement.
External beeper is also provided for louder tone
at the end of a count.
A USB port that can be used to output data to a
USB printer or storage device (flash drive or
external hard drive).
A serial port used to connect the gauge to a
computer or printer for data transfer and
printing.
Calibration offsets (density and trench) to
expand measurement possibilities, and to enhance
gauge readings on materials that may fall outside
the range of factory calibration.
To Next Page
Loading...
Need help?
General
