Troxler EGauge Combo 4540 - Unpacking and Inspection

Model 4540
1–7
Unpacking and Inspection
Upon receipt of the gauge from the factory, perform a complete
inspection and inventory. If the shipping case and/or any other
part or accessory appears damaged, immediately notify the
carrier and your Troxler representative 1-877-TROXLER (1-
877-876-9537).
Save the box and any packing material for shipping to another
location or back to the factory. For shipping instructions and
regulations, please see Appendix C.
Inspection
Upon receiving the Model 4540 from the factory, perform a
complete inspection and inventory as described below.
 Gauge
 Drill Rod
 Scraper Plate/Drill Rod Guide
 Extraction Tool
 AC Charger
 DC Adapter
 Manual of Operation and Instruction
 Gauge Certificate
 Transportation Guide
Lift the gauge from the transport case and inspect the outside
surfaces for damage. Check the lock on the source rod handle
and make sure the keys fit. Remove the lock, release the trigger,
and check the source rod operation. It should move up and
down with little effort. Return to the safe position, replace the
handle lock and return the gauge to the transport case.