Manual Store
After completing a measurement and before taking another one,
sample data can be stored manually under the active project.
Refer to pages 8–3 through 8–5 for instructions on creating and
selecting the active project.
To manually store measurement data, press the STORE key
while data is being displayed. If no project is active when the
STORE key is pressed, the gauge displays the error message
No active project!, then returns to the Ready screen.
NOTE
The STORE key is active only when measurement
data is displayed. Measurement data is displayed at
the end of a reading, or the most recent test results
can be displayed using the RECALL key (see page 4–
20).
For each measurement, the gauge can store a location
description of up to 12 characters, as well as a note of up to 15
characters.
To Next Page
Loading...
