Turning the Gauge On
NOTE
Charge the batteries for three to four hours prior to
initial use.
The gauge uses rechargeable NiMH batteries as a power source.
Press the power switch to turn the gauge to the on position.
When powered on the display screen fills with test characters
before proceeding to the two-second self-test phase.
Afterwards, the gauge enters a 300-second warm-up period.
During the warm-up period, the gauge displays the gauge model
number, software version, serial number, company name (if
programmed), and progress (in seconds) of the warm-up.
After the self-test, press any key to enter the Ready mode.
The gauge displays Self-Test Please Wait message mode when
the gauge is ready to proceed to another menu. The screen
displays:
To Next Page
Loading...
