The moisture probe must be charged periodically. The probe will
operate approximately 35 hours per charge. The red LED (3
rd
light from left) illuminates when low, indicating approximately 4
hours of use remaining. Charge the probe with the charger
supplied with the Troxler EGauge. The yellow LED illuminates
during charging. The probe fully charges in approximately
4hours (max). Refer to M6760 at troxlerlabs.com.
Figure 1.1: Probe in Measurement Mode
Calibration
Troxler calibrates the gauge at the factory and recommends that
it is always calibrated by an authorized Troxler service center. A
list of Troxler and authorized Troxler service centers are
provided at the front of this manual or at:
www.troxlerlabs.com/services.
The calibration range of the gauge’s density measurements is
from 1750 to 2700 kg/m
3
(approximately 110 to 170 pcf).
NOTE
Moisture content of the measured material can
be determined with an external device, such as
the Troxler Moisture Probe Model 6760. Other
manual methods, such as an oven dry, may also
be used
To Next Page
Loading...
Need help?
General
